Motor vehicles

Hi

I've got a 4.2 engine in the garage. So far I only have a board with two small furniture scooters under it to at least move him a little. But that's not a permanent solution.

Now I'm thinking about what a car like that might look like. First of all, the weight lasts... and secondly, good to move is... And thirdly, keep the engine stable when I screw it around.

I was thinking...

4 heavy duty castors (relatively large wheel diameter, of which 2 steering bar, one with brake)
then I have nice hardwood boards with about 5 cm thickness and 20 cm width.

If I screw these properly together, and look at the oil pan right down there, it would have to be done. The question is how wide I do it, so that it doesn't tilt, and whether I put additional supports or eyelets on it for tethers.

Maybe someone's got a good example... or other ideas...

Frank